building material cold rolled coil

The material composition of the product is mainly iron carbon alloy, generally containing a small amount of silicon,manganese, sulfur and phosphorus. Different brands correspond to different hardness, thermoplastic, plasticity and weldability. If you don’t understand, you can tell us your requirements.

The process of cold rolling increasing the SGCC DX51D ZINC Cold rolled coil’s strength and hardness, while decreasing its ductility.

Cold-rolled sheet in coil form is produced by removing rust from hot-rolled sheet by “pickling” it in a weak acid solution, then washing, brushing, drying, oiling and unrolling the sheet and finally performing cold-rolling by passing the sheet through a reducing mill under pressure and winding it into a roll.

The steel coil is a product of rolling and winding a piece of steel strip or steel sheet. The width of a steel coil is larger compared to its thickness. The method of producing steel coil is based on how it should be classified, whether as a cold-rolled, galvanized or hot rolled steel coil.

This Customize Cold Rolled Galvanized Steel Coil Hc220bd is based on cold -rolled steel strip as substrate,after continuous hot-dip galvanizing process and produced products.It is an excellent resistance to atmospheric corrosion of coated steel,cold-rolled sheet coil after the galvanized can extend the service life for 15-20 years.

Cold-rolled is processed from hot-rolled sheets at room temperature. Although the temperature of the steel sheet will be heated during the processing, it is still called cold-rolled. Due to the continuous cold deformation of hot rolling, the mechanical properties are relatively poor and the hardness is too high.

Cold-rolled steel coil is better in surface quality (such as Surface roughness) than hot plate because it is obtained by cold rolling and some surface finishing is carried out at the same time. Therefore, if the product after the sequence of painting, such as coating quality, there are higher requirements, the general choice of the cold plate.

Cold rolled steel coil is rolled at room temperature and then rolled again below its recrystallization temperature. This process enables better control over finished product shape, thickness, dimensions, and a more consistent finish.

Cold-rolled coils are widely used, such as automobile manufacturing, electrical products, rolling stock, aviation, precision instruments, canned food, etc. Cold-rolled sheet is the abbreviation of ordinary carbon structural steel cold-rolled sheet, also known as cold-rolled sheet, commonly known as cold-rolled sheet, and sometimes mistakenly written as cold-rolled sheet. The cold plate is a hot-rolled steel strip of ordinary carbon structural steel, which is further cold-rolled into a steel plate with a thickness of less than 4mm.

Galvanized steel coil, also known as galvanized coil, is a galvanized coil product. Galvanized coil, a steel material coated with zinc. The galvanized coil is the predecessor of the galvanized sheet. The galvanized coil is cut into sheets by equipment. The galvanized coil is placed on the shelf with a forklift or aerial crane, and then transferred, flattened and cut by the equipment.

Cold rolled steel coil is a type of steel coil product developed from hot rolled steel coil and sheet, surface quality and dimension precision are quite low after hot rolling process, it can’t be used where surface quality and dimensions are required. Until now, cold rolled coils have been available and successfully used for a variety of applications.